SHANGHAI
CMIC
CMIC
- This machine is controlled by computer, can install two groups of wave shafts at the same time, perform fast wave shaft replacement without replacement, move the wave axis outward, improve production efficiency, minimize labor intensity. of the operator, the shaft replacement time only takes 5 minutes. A normal production waveform uses a pre-heated batch of waves, with a heating time of about 20 minutes.
- This machine works according to hydraulic technique, ensuring stable high speed operation and good bonding.
- Independent clutch ball-wave shaft moves without locking structure.
- Using three direct drive points of movement, the production speed is enhanced.
- This machine is suitable for middle and high grade production line.
- Using high-pressure centrifugal suction fan, Using an economical control inverter equipped with low noise and noise cancellation.
- The upper and lower wave shaft diameter Ф 360 mm, adopts precise abrasive type heat treatment. The surface is plated with chromium.
- The surface of the paper guides, the pre-heater and the reinforcement platen are all anti-wear machined and hard chromium plated.
- The lubrication of the whole machine uses lubricating oil of high temperature resistant type, centralized lubrication, maintenance of oil is convenient.
- Using infrared sensor to detect paper board breakage, perform automatic protection when paper is broken, pressure shaft automatically withdraws, the glue tank withdraws, then stops the machine and operates with slow speed.
- The surface of the glue lot uses a 26-wire / inch mesh, the hard chromium-plated surface makes the amount of glue smaller and more stable.
- The amount of glue is more or less controlled by electrodynamics and automatically controlled. Based on the production speed of the production line and through the motor to adjust the amount of glue appropriately.
- At automatic, different speeds of the transcoder and PLC are automatically completed, and at the same time display the numeric value on the screen interface, to ensure the required amount of glue when the single-sided corrugated mill operating at different speeds, ensuring the stability as well as the quality of the single-sided corrugated mill.
- The machine base adopts the same good quality of steel, the pressure and movement are unified, the gearbox starts independently, realizes the signal transmission between the inverter and PLC, controls the acceleration and deceleration of the Single-sided corrugated iron saves energy while remembering information into input of production management system.
- Upper wave plots, lower wave plots, pressure gauge plots, glue casters, and glue coated batches use Japanese NSK bearings.
- The inverter uses a German product from Siemen.
- PLC uses products of Siemens Germany.
- The raw material is dynamic using high quality Chinese products.
- The body is constructed of cast steel HT150.
- Parametric adjustment contact screen interface using Taiwan ASK products, display language in English or Chinese.
- Use composite glue wiper (knife with stainless steel material + conveyor).
There are no videos for this product yet...
Related Products
